12-33
4. Coat the inspection plug’s threads with the
specified sealant and install and tighten the
plug.
4.2 Replacement
1. Remove inspection plug and drain plug to
let the oil flow out.
NOTE:
Oil removal is quicker if performed soon after the
vehicle has been stopped and while the oil is still
hot.
2. The drain plug is fitted with a magnet. Wipe off
any metal particles sticking to the magnet.
3. Replace the gasket of the drain plug with a new
one.
4. Coat the threads of the drain plug with the spec-
ified sealant.
5. After transfer oil has drained out completely,
install and tighten the drain plug.
6. Add oil through the inspection plug hole until it
reaches the bottom of the hole.
Put your finger straightly into the inspection plug
hole after one minute has passed, and check
that the oil is filled up to the opening of the hole.
Sealant ThreeBond 1105
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
WARNING
Do not replace the oil immediately after driv-
ing, as you could be scalded by extremely
hot oil. Give the oil time to cool before drain-
ing it.
Sealant ThreeBond 1105
Tightening torque
68.6 ± 14.7 N·m (51 ± 11
ft.lbs., 7.0 ± 1.5 kgf·m)
FE_FG.book Page 33 Monday, December 19, 2011 4:22 PM
To Next Page
Loading...
