12-7
• Park the vehicle on a flat and level surface and
stop the engine.
Tilting the cab on a slope is dangerous since the
cab could swing up unexpectedly. This could
also damage the mechanism because of the
huge, sudden stresses on it.
• Prevent the vehicle from moving by pulling the
parking brake lever and blocking the wheels
with chocks.
• Put the gearshift lever in the “P” position.
• Remove water or other liquids from inside the
cab before tilting. Also, remove from the cup
holders any beverage whose container is open.
• Close both doors completely.
• Before tilting the cab, make sure there is ade-
quate clearance in front of the cab and above it.
If there are any obstructions within the clear-
ance areas shown above, remove them.
• Retract the radio antenna.
2 Tilting the cab
CAUTION
Raise the cab gently. Raising it quickly with
great force could damage the cab tilt mecha-
nism.
1. Pull lever A . With lever A still pulled, pull up
lever B . Keep lever A pulled until the lever B
has been fully raised.
CAUTION
Lever B must only be raised when lever A has
been pulled. If an attempt is made to raise lever
B by force, it may be damaged as a result.
Clearance in front 1 m or more (3.3 ft. or more)
Clearance above 1 m or more (3.3 ft. or more)
Z09214
FE_FG.book Page 7 Monday, December 19, 2011 4:22 PM
To Next Page
Loading...
Need help?
General
