5-29
• Start the vehicle only when the gear position
indicator indicates “1”, “2” or “3”. When
starting after the ABS has been activated,
the system may take longer than usual to
engage the starting gear.
1. Fully depress the brake pedal.
2. Move the gearshift lever from the “D” position to
the “+” or “–”position.
• The gear shifts up by one gear each time you
move the lever to “+”.
• The gear shifts down by one gear each time you
move the lever to “–”.
The “ ” indication on the multi-information dis-
play disappears when the manual shift mode is
engaged.
The gearshift mode also can be changed between
“manual” and “automatic” each time you push the
gearshift lever from the “D” position into the “A/M”
position.
NOTE:
The starting gear engagement is still in progress
while the indication on the gear position indicator is
flashing. Do not release the brake pedal at this time.
3. Make sure the gear position indicator is showing
the desired gear.
4. Release the parking brake. Slowly depress the
accelerator pedal while gradually releasing the
brake pedal to start the vehicle.
Z21538
Z21539
Z21540
Z21537
FE_FG.book Page 29 Monday, December 19, 2011 4:22 PM
To Next Page
Loading...
