28
No. 99MBC139A
3 Operation Procedure
5
Set tolerance value S1 (tolerance indicator display: ).
Using the [MODE] (>) key to move between digits,
change the digit values using the [P.SET] (^) key.
MODE
Fn
SEL
/
CE
Ch.
TIR
P.SET
1
Tips
• If you wish to set a negative tolerance value, you can change the highest-order digit to a minus sign.
• The direction in which digit selection and number setting proceeds can be reversed by pressing the [MODE]
(>) or [P.SET] (^) key together with the [Fn] key.
6
Press the [SEL/CE] key.
» Tolerance value S1 will be applied.
MODE
Fn
SEL
/
CE
Ch.
TIR
P.SET
1
Setting 3-step tolerance
MODE
Fn
SEL
/
CE
Ch.
TIR
P.SET
1
Setting 5-step tolerance
» When setting 3-step tolerance values, display enters the tolerance value S4 (tolerance indicator display:
) setting screen.
» When setting 5-step tolerance values, display enters the tolerance value S2 (tolerance indicator display:
) setting screen.
Tips
The state of the tolerance indicator changes in the following sequence according to the tolerance value settings
(S1, S2, S3 and S4).
Tolerance value
Tolerance indicator
3-step tolerance value
setting
5-step tolerance value
setting
S1 S1
— S2
— S3
S4 S4
7
Repeat steps
5
to
6
to set tolerance value S4 (tolerance values S2, S3 and S4 when setting
5-step tolerance values).
Tips
Display returns to the preset value setting screen of step 2 when you press the [SEL/CE] key while in the toler-
ance value S4 setting screen.
To Next Page
Loading...
