Mitutoyo ID-C112GXB - Page 56

No. 99MAH040B
5-3
Display
definition
Actions
Internal program error
・ Measurement cannot be
performed due to
occurrence of an
anomaly in the internal
program.
・ This could be due to
instrument failure. In this
case, contact your dealer or
Mitutoyo sales office.
Tolerance upper/lower limit
setting error
・ The tolerance limit value
is set with the upper limit
value being smaller than
the lower limit value.
・ Press the center key to
reset to be the upper limit
value is greater than the
lower limit value. (Refer to
"3.3.1 TOL: Tolerance
judgment".)
Overflow error of preset
value
・ The preset value has
exceeded the maximum
number of digits that can
be displayed.
・ Press the lower right key to
reset the preset value.
・ Lower the resolution. (Refer
to "3.3.2 RES: Resolution".)
Overflow error of upper limit
value
・ The upper limit value has
exceeded the maximum
number of digits that can
be displayed.
・ Press the lower right key to
reset the upper limit value.
(Refer to "3.3.1 TOL:
Tolerance judgment".)
・ Lower the resolution. (Refer
to "3.3.2 RES: Resolution".)
Overflow error of lower limit
value
・ The lower limit value has
exceeded the maximum
number of digits that can
be displayed.
・ Press the lower right key to
reset the lower limit value.
(Refer to "3.3.1 TOL:
Tolerance judgment".)
・ Lower the resolution. (Refer
to "3.3.2 RES: Resolution".)