4.3 Cleaning and Lubricating Z2-Axis Column
The guide surface of the Z2-axis column requires periodic lubrication (about once a
ning the column guide surface with a soft cloth, apply a few drops of the included
4.4 Lubrication
month).
After clea
lubricant (Mobil: Oil Bactra #2) on the Z2-axis column guide surface, near the upper edge.
Periodically apply the lubricant in accordance with the lubrication conditions.
The ball screws and linear guides incorporated in this machine require lubrication
ince this
TIP
Mitutoyo performs periodic maintenance (at an extra-cost) including accuracy inspection
periodically (approximately yearly or every 2000 hours, whichever comes first).
An authorized service engineer must perform this lubricating operation s
maintenance is performed inside the machine. Whenever lubrication is required, consult
your dealer, or the nearest Mitutoyo sales office or service center.
and lubrication. To retain the highest possible performance from this system for an
extended period of time, it is recommended that a Mitutoyo service engineer perform
periodic maintenance. For detailed information about maintenance contracts and
periodic maintenance, contact your dealer or the nearest Mitutoyo sales office.
Z2-axis column guide
surface
No. 99MBB187A
4-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
