5. TROUBLESHOOTING
5.2 Trouble during Surface Roughness Measurement
Symptom Check points Remedies
1) Are the attached detector
holder and detector loose?
1) Tighten the clamp ring on the
connector unit.
1 Measurement results
include a significant
component of vibrations.
2) Does external vibrations affect
the measurement results?
2) Tighten the clamp ring on the
connector unit.
2 Measurement results are
abnormal.
1) Has the detector been
calibrated correctly?
1) Recalibrate the detector.
1) Is the power switch on the
controller turned on?
1) Turn on the power switch on
the controller.
3 The analysis software will
not start up properly.
2) Is the connecting cable
between the controller and
personal computer connected
correctly?
2) Check the cable for the
connection state and connect it
correctly.
If any other problems are encountered, contact your dealer or the nearest Mitutoyo sales office.
No. 99MBB187A
5-3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
