Optional Accessories
6.3.1 Optional accessories
Order No. Name Remark
178-611 Step gage (mm)
178-612 Step gage (inch)
12AAG202 Extension rod 50
A rod that extends the rough detector by 50mm.
12AAG203 Extension rod 100
A rod that extends the rough detector by 100mm.
12AAG175 Calibration Stage
A 70 mm-high stage to be installed on the base. This
is necessary when the calibration kit is used because
the lower edge of the stylus is 70 mm high (when the
arm is horizontal). This is not necessary when the
cross-travel table, plain table, cross-travel stage, or
three-axis adjustment table is used.
218-001 Cross-travel table (mm)
218-011 Cross-travel table (inch)
218-041 Cross-travel table (50×20mm)
218-051 Cross-travel table (2”×1”)
178-016 Leveling table
218-002 Table (fixed type)
178-019 Precision vise
218-003 * Rotary vise
172-196 * Rotary table
176-107 * Holder with clamp
172-144 * Rotary vise
172-197 * Rotary vise
178-042-1 Cross-travel table (Digimatic) (mm)
178-052-1 Cross-travel table (Digimatic) (inch)
178-043-1 Cross-travel table (vernier) (mm)
178-053-1 Cross-travel table (vernier) (inch)
178-047 Three-axis adjustment table
172-234 * V-block with clamp
172-378 * V-block with clamp
998291 V-block with clamp
172-142 * Center support
172-143 * Riser
178-023 Vibration isolator Pump supply type, supports only standard base type
178-024 Stand for vibration isolator
178-025 Vibration isolator Air supply type, supports only standard base type
166-215 Workbench (with drawers)
218-007 Workbench
218-008 Workbench
218-010 Workbench
No. 99MBB187A
6-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
