76
e) Checking the Servo Function
To run a test, connect the servos used to the receiver. Pay attention to the assignment of the receiver outputs as
described above.
Take the remote control into operation, then the receiver. If attached correctly, the servos should react to movement of
the control sticks at outputs 1 - 4. The servos at the outlets 5 and 6 react depending on the models programmed to the
transmitter and/or the activated switches and controllers. For more information on transmitter programming, see the
following chapter (Programming the Remote Control Transmitter).
Attention, important!
Always switch on the transmitter first, then the receiver. When you switch off the devices, always switch off
the receiver first, then the transmitter.
Never switch off the remote control as long as the receiver is in operation. This can lead to unexpected
reactions by the model!
To Next Page
Loading...
Need help?
General
