90
l) Reset to Factory Settings “Factory reset”
With this function you have the option of deleting all the data of all model memories to their factory settings with a
single command.
Attention!
When you call this function, all previously entered model data and settings are deleted! The remote control
is returned to the delivery condition and all data must be entered again.
Factory reset
• Switch on the transmitter and call the system setting menu.
• Move the cursor arrow to the menu item “Factory reset” with the scroll
wheel.
• Briefly confirm the scroll wheel button or the button “OK” to activate the
menu item.
The display shows the message that the transmitter deletes all entered
settings when resetting to factory settings. You are asked to push the button
“OK” to activate the reset function.
• After pushing the button “OK”, a safety prompt appears.
• Turn the scroll wheel to switch the cursor arrow from “No” to “Yes” and
push the button “OK” again to activate the reset function. The display
shows the system setup menu again after a moment.
• Push the button “CANCEL” repeatedly until you get back to the operating
display.
• Then check the individual model memories afterwards for whether the
personal setting values in them have been deleted.
Figure 26
To Next Page
Loading...
