82
d) Copying Model Memory “Model copy”
For simple programming of the system you have the option of copying data from one model memory to another. This
helps to easily transfer basic settings and mixer between similar models and you only need to adjust the settings
values to the new model.
Copying model data into another model memory:
• Switch on the transmitter and call the system setting menu.
• Move the cursor arrow to the menu item “Model copy” with the scroll wheel.
• Briefly confirm the scroll wheel button or the button “OK” to activate the
menu item.
The display shows two model memories with the respective activated model
names and the associated model type figure. The model memory above is
the data source and the model memory below is the target memory.
• Turn the scroll wheel to select the model memory from which the data are
to be copied.
• Briefly push the scroll wheel button to switch to the target memory.
• Turn the scroll wheel to select the model memory into which the data are
to be copied.
• Push the button “OK” to start copying. The display now shows a safety
prompt.
• Turn the scroll wheel to switch the cursor arrow from “No” to “Yes” and
push the button “OK” again to copy. The display then shows the system
setup menu again.
• Push the button “CANCEL” repeatedly until you get back to the operating
display.
Since the model name is also copied, call the model memory into which you copied the data right after
copying and enter the name of the new model there at once. This avoids undesired mistakes among the
model memories.
Figure 18
To Next Page
Loading...
Need help?
General
