80
b) Model Name Setting “Model name”
In order to be able to discern between model memories more easily it makes sense to give the memories the name of
the corresponding models. The name can consist of a combination of up to 8 letters, numbers or characters.
Attention, important!
You can only change the name of the model memory that is also active at the moment. When you want to
change the name of another model memory, you need to first call and activate the desired model memory.
Setting the model name
• Switch on the transmitter and call the system setting menu.
• Move the cursor arrow to the menu item “Model name” with the scroll
wheel.
• Briefly confirm the scroll wheel button or the button “OK” to activate the
menu item.
The display shows the currently set model memory with the model name.
The first letter in the name is already backlit back and can be set.
• Turn the scroll wheel to select the desired letter. The arrow pointing to the
right at the lower display edge indicates that the remaining letters and
special characters are available on a second display page.
• Push the scroll wheel button to switch to the second letter. The second
letter then gets a black background.
• The second letter is set according to the same pattern as the first one.
• Repeat the above procedure until desired model name has been
programmed.
• Push the button “OK” to save the set model name. The display then shows
the system setup menu again.
• Push the button “CANCEL” repeatedly until you return to the operating
display and check if the desired model name is set correctly.
Figure 16
To Next Page
Loading...
Need help?
General
