79
a) Model Memory Selection “Model select”
The remote control system has 20 model memories which allow you to save the data for your respective models
independently of one another. Therefore, it is required to et the associated model memory in the transmitter before
operating a specific model.
Setting the model memory
• Switch on the transmitter and call the system setting menu. The top menu
item “Model select” is marked by the cursor arrow.
• Briefly confirm the scroll wheel button or the button “OK” to activate the
menu item.
The display shows the currently activated model memory. Additionally, the
model name and a model type figure are displayed.
• Turn the scroll wheel to select the desired model memory 1 - 20.
• Push the button “OK” to select the desired model memory. The display
then shows the system setup menu again.
• Push the button “CANCEL” repeatedly until you return to the operating
display and check if the desired model memory is set.
Figure 15
To Next Page
Loading...
