89
k) Transmitter Software Update “Firmware update”
To transfer a never version of the transmitter software to the remote control, the transmitter must be connected to a PC
or notebook with an USB interface cable. For the data to be received by the computer, the transmitter must be put in
the update mode. No receiver that belongs to the transmitter must be activated during this process.
Activating transmitter software
• Switch on the transmitter and call the system setting menu.
• Move the cursor arrow to the menu item “Firmware update” with the scroll
wheel.
• Briefly confirm the scroll wheel button or the button “OK” to activate the
menu item.
The display shows a message that the transmitter is switched to the update
mode and all functions are stopped. You are asked to push the button “OK”
to activate the update function.
• After pushing the button “OK”, a safety prompt appears.
• Turn the scroll wheel to switch the cursor arrow from “No” to “Yes” and
push the button “OK” again to activate the update function.
The push of the button is in this case not confirmed with a sound but the
display lighting is darkened.
The display shows that the update function is active.
The data transmission can now be started at the computer. All buttons at
the remote control are out of order during the transmitter software update.
Switch the transmitter off and on again after the data transmission is
completed.
Important note:
Since the remote control was already equipped with the latest transmitter software ex works, a software
update is usually not required. If it is required to renew the transmitter software in case of malfunction,
send the remote control to our customer service department in Hirschau.
Figure 25
To Next Page
Loading...
Need help?
General
