ModelCraft FS-T6 User Manual

83
e) Deleting Model Memory “Model reset”
To remove any present and undesired settings before programming a new model, you can delete individual model
memories targetedly and thus rest them to factory settings.
Deleting model memory:
• Switch on the transmitter and call the system setting menu.
• Move the cursor arrow to the menu item “Model reset” with the scroll wheel.
• Briefly confirm the scroll wheel button or the button “OK” to activate the
menu item.
The display shows the currently set model memory with the model name
and model figure.
• Turn the scroll wheel to select the model memory to be reset to default.
• After pushing the button “OK”, a safety prompt appears.
• Turn the scroll wheel to switch the cursor arrow from “No” to “Yes” and
push the button “OK” again to delete the model memory. The display then
shows the system setup menu again.
• Push the button “CANCEL” repeatedly until you get back to the operating
display.
Figure 19

ModelCraft FS-T6 Specifications

General

Brand	ModelCraft
Model	FS-T6
Category	Remote Control
Language	English