91
14. The Function Setting Menu “Functions setup”
The specific settings for the respective models are made in the function
setup menu. The menu items available in the function setup menu depends
on which model type was selected in the system setup menu.
To get to the function setting menu, push and hold the scroll wheel for about
1 second with the transmitter on. The operating display in the display switches
to the menu display. The selection window around the remote control icon
shows that you can call the system setup menu in this setting.
Move the scroll wheel to the left or right for the selection window to frame
the tools.
Briefly confirm the scroll wheel button or the button “OK” to get to the function
setup menu.
The first 6 menu items of the function setting menu are now displayed.
The following setting functions are available for you in the function setting
menu:
Function Display
Servo direction setting “Reverse”
Servo end deflection setting “End points”
Servo control/test “Display”
Encoder assignment “Aux. channels”
Basic trim “Sub-trim”
Dual rate/exponential setting “Dual rate/exp.”
Throttle curve setting “Throttle Curve”
Pitch curve setting (only for helicopters with pitch function) “Pitch Curve”
Swash plate servo settings “Swash AFR”
Mixer programming “Mix”
Delta mixer (for flight models only) “Elevon”
V-tail mixer (flight models only) “V tail”
Gyro sensitivity setting (for helicopter models only) “Gyroscope”
Switch assignment “Switches assign”
Throttle switching “Throttle hold”
Figure 27
To Next Page
Loading...
Need help?
General
