Moeller DF5 series - Parameter Menu Navigation

09/01 AWB8230-1412GB
Operation with LCD keypad
45
Table 8: Explanation of the parameters
For a detailed explanation of the parameters, see Section ”Setting
Parameters”, Page 75.
Changing display and basic parameters
Press the PRG key to switch from display or RUN mode to
programming mode. The PRG lamp lights up in this mode.
You can access the individual parameters or parameter groups
with the UP and DOWN arrow keys (a Fig. 40).
To access the programming mode, press the PRG key. You can
modify the parameter values with the arrow keys.
Exceptions are the display parameters PNU d01 to d09. These
parameters have no values. After you have selected a display para-
meter with the arrow keys, you can return to the display mode with
the PRG key. The display reflects the selected display parameter
(a Section ”Setting the display parameters”, Page 75).
Parameter values can be accepted with the ENTER key or rejected
with the PRG key.
By pressing the PRG key in the range of the display parameters
PNU d01 to d09, you return to the display mode.
Figure 40: Menu structure of the DF5 keypad
a The display is dependant on the display parameter
(PNU d01 to d09) from which you return.
a
PRG
PRG
PRG
PRG
Display Explanation
Display
parameter
d 01 Output frequency display
d 02
Output current display
d 03
Direction of rotation display
d 04
PID feedback display
d 05
Digital inputs 1 to 5 status
d 06
Status of digital outputs 11 and 12
d 07
Scaled output frequency
d 08
Display of last alarm
d 09
Display of second and third to last alarm
Basic
parameters
F 01 Frequency setpoint adjustment
F 02
Set acceleration time 1
F 03
Set deceleration time 1
F 04
Direction of rotation adjustment
Extended para-
meter groups
A -- Extended functions group A
b --
Extended functions, group B
C --
Extended functions, group C