DF5 Operation
09/01 AWB8230-1412GB
46
Example for changing acceleration time 1: PNU F02
The frequency inverter is in the display mode and the RUN lamp is
lit.
X Press the PRG key.
The frequency inverter changes to the programming mode, the
PRG lamp lights up and d01 or the most recently modified para-
meter appears on the display.
X Press the DOWN key six times until F02 appears on the
display.
X Press the PRG key.
The set acceleration time 1 in seconds appears on the display (WE
= 10.0).
X The set value is changed with the UP and DOWN arrow keys.
There are now two possibilities:
X Accept the displayed value by pressing the ENTER key.
X Reject the displayed value by pressing the PRG key.
The display responds with F02.
X Press the DOWN key six times until d01 appears on the
display.
X Press the PRG key.
The frequency inverter changes over to the display mode and
displays the set frequency.
Changing the parameters of the extended parameter
groups
The following example illustrates how to change PNU A03 of the
extended parameter group A. You can change the parameter
values of groups B and C exactly as described in the example. For
a detailed description of the extended parameter groups, see from
Section ”Setting the frequency and start command parameters”,
Page 78.
An example of how to change the base frequency PNU A03
X Press the PRG key to change over to the programing mode.
The most recently modified parameter appears on the display and
the PRG lamp lights up.
X Press the UP or DOWN key until the extended parameter group
A-- appears on the display.
X Press the PRG key.
The display indicates A01.
X Press the UP key twice until A03 appears on the display.
X Press the PRG key.
The value set under PNU A03 (WE = 50.0) appears.
X You can change the value with the UP and DOWN arrow keys.
There are now two possibilities:
X Accept the displayed value by pressing the ENTER key.
X Reject the displayed value by pressing the PRG key.
The display indicates A03.
X Press the PRG key.
The display indicates A--.
X Press the DOWN key three times until d01 appears.
X Press the PRG key.
Figure 41: Change acceleration time 1
a Display dependent on the selected display parameter PNU d01 to
d09
b Display of the most recently changed parameter
a
b
F02 = 9.9
F02 = 10.0
PRG PRG
PRG
PRG
ENTER
6 x
To Next Page
Loading...
