09/01 AWB8230-1412GB
Display after the supply
voltage is applied
47
The frequency inverter changes over to the display mode and
displays the current frequency.
Display after the supply voltage is applied
After the supply voltage is switched on, the last screen which was
visible before switch off will reappear (not, however, within the
extended parameter groups).
Figure 42: Change the base frequency (example with default setting)
a Display dependent on the selected display parameter PNU d01 to d09
b Display of the most recently changed parameter
a
b
A03 = 49.9
A03 = 50.0
PRG PRG
PRG
PRG
PRG
PRG
ENTER
3 x
To Next Page
Loading...
