Moeller DF5 series - About this Manual; Abbreviations and Symbols

Contents
09/01 AWB8230-1412GB
2
4 DF5 Operation 43
Initial startup 43
LCD keypad 44
Operation with LCD keypad 44
– Menu overview 44
– Changing display and basic parameters 45
– Changing the parameters of the extended
parameter groups 46
Display after the supply voltage is applied 47
Operational warning message 48
5 Programming the control signal terminals 49
Overview 49
Frequency display FM 52
– Analog frequency display 52
– Digital frequency display 53
Programmable digital inputs 1 to 5 54
Start/Stop 55
Fixed frequency FF1 to FF4 selection 56
– Current setpoint value AT (4 to 20 mA) 58
– Second time ramp 2CH 59
– Controller inhibit and coasting of the
motor FRS (free run stop) 60
– External fault message EXT 61
– Restart inhibit USP 62
– Reset: RST 63
–Jog mode (JOG) 64
– PTC thermistor input: PTC 65
– Software protection SFT 66
Programmable digital outputs 11 and 12 67
Frequency value messages FA1/FA2 68
– RUN operational 70
– Overload message OL 71
– PID controller deviation message OD 72
– Error message AL 73
Signalling relay terminals K11, K12, K14 74