Moeller DV6-340 Series - Page 205

Appendix
01/02 AWB8230-1415GB
202
A073 I component of the PID control [s] 1.0 138
A074 D component of the PID control [s] 0.0 138
A075 Setpoint factor of the PID control [%] 1.00 138
A076 Input actual value signal for PID control
• 00: Input OI
• 01: Input O
00 138
A081 AVR function
• 00: Active
• 01: Inactive
• 02: Inactive during deceleration
02 146
A082 Motor voltage for AVR function [V] 230/400 146
A085 Energy-saving mode
• 00: Not active
• 01: Active
• 02: With fuzzy-logic active
00 147
A086 Response time in energy-saving mode [s] 50 147
A092 Second acceleration time [s] 15.0 74
A292 Second acceleration time (second parameter set) [s] 15.0 74
A392 Second acceleration time (third parameter set) [s] 15.0 74
A093 Second deceleration time [s] 15.0 74
A293 Second deceleration time (second parameter set) [s] 15.0 74
A393 Second deceleration time (third parameter set) [s] 15.0 74
A094 Switch-over from the 1st time ramp to the second time
ramp through
• 00: Input 2CH
• 01: PNU A095 or A096
00 74
A294 Switch-over from the 1st time ramp to the second time
ramp through
• 00: Input 2CH
• 01: PNU A095 or A096
(second parameter set)
00 74
A095 Changeover frequency from first to second acceleration
time
[Hz] 0.00 148
A295 Changeover frequency from first to second acceleration
time (second parameter set)
[Hz] 0.00 148
A096 Changeover frequency from first to second deceleration
time
[Hz] 0.00 148
A296 Changeover frequency from first to second deceleration
time (second parameter set)
[Hz] 0.00 148
A097 Acceleration characteristic
• 00: Linear
• 01: S-curve
• 02: U curve
• 03: Inverted U curve
00 150
A098 Deceleration characteristic
• 00: Linear
• 01: S-curve
• 02: U curve
• 03: Inverted U curve
00 150
A101 Analog input OI starting frequency [Hz] 0.00 64
A102 Analog input OI end frequency [Hz] 0.00 64
PNU Function Units Default Page Setpoint
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616