01/02 AWB8230-1415GB
Standard form for user defined
parameter settings
205
b037 Display mode
• 00: All parameters
• 01: Relevant parameters
• 02: Parameters saved under PNU U001 to U012
00 164
b040 Selection of torque limitation
• 00: All four quadrants
• 01: Changeover to digital inputs TRQ1 and TRQ2
• 02: Analog input O
• 03: Optional module in slot 1
• 04: Optional module in slot 2
00 95
b041 Torque limit, first quadrant [%] 150 95
b042 Torque limit, second quadrant [%] 150 95
b043 Torque limit, third quadrant [%] 150 95
b044 Torque limit, fourth quadrant [%] 150 95
b045 Response on reaching the torque limit
• 00: Wait with acceleration or deceleration until
below limit
• 01: No response
00 95
b046 Reverse rotation protection
• 00: Anticlockwise operation allowed
• 01: Anticlockwise operation not allowed
00 95
b050 Controlled deceleration
• 00: Active
• 01: Not active
00 161
b051 Starting voltage for deceleration [V] 0.0 161
b052 Voltage for ramp stop [V] 0.0 161
b053 Deceleration time for ramp stop [s] 1.00 161
b054 Frequency jump on ramp stop [Hz] 0.00 161
b080 Gain factor, analog output AM 180 57
b081 Gain factor, analog output FM 60 59
b082 Increased starting frequency (e.g. with high level of
friction)
[Hz] 0.50 104
b083 Carrier frequency [kHz] 5.0 164
b084 Initialization causes
• 00: Clearing of the fault history register
• 01: Selection of default settings
• 02: Deleting the fault history register and restoring
the default settings
00 165
b085 Country version
• 00: Japan
• 01: Europe
• 02: USA
01 165
b086 Frequency factor for indication through PNU d07 1.0 165
b087 OFF key
• 00: Always active
• 01: Not active with control through the FWD/REV
terminals
00 165
b088 Motor restart after removal of the FRS signal
• 00: With 0 Hz
• 01: With current motor speed
00 166
PNU Function Units Default Page Setpoint
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616
To Next Page
Loading...
