Monarch SE 2004 - Greasing

Monarch SE 2004----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Section 3 Exterior & Interior | 141
When preparing to use a high-pressure grease gun, thoroughly clean all Zerk
grease fittings before applying new lubricant. Keep paper towels or disposable
rags handy when greasing. When lubricating items such as drive shafts and steer
axles components, continued grease application is generally required until new
grease appears at exit points.
Some items use sealed boots around the component to prevent moisture
intrusion. When greasing these types of components care must be given to prevent
excess lubricant pressure from rupturing the seal.
WARNING: Always chock wheels before going underneath the
motorhome.
To apply grease:
• Clean the grease fitting. Initially operate grease gun until new
lubricant discharges from nozzle then wipe nozzle clean. This avoids
introducing contaminants into the component.
• Snap nozzle onto grease fitting.
• Nozzle must remain inline with the grease fitting during the application
process. If the nozzle is not in line, lubricant will collect around
nozzle and grease fitting, failing to lubricate the component.
• Wrap the nozzle with a paper towel or rag to prevent contamination and
accidental soiling of other areas.
If the component does not accept grease the Zerk fitting may be plugged or
damaged. Zerk fittings are replaceable and generally available at most auto supply
stores. Zerk fittings come in variety of angles depending on the application.
Every effort should be made to lubricate the component, as neglect will only
result in premature component failure.
NOTE: Some grease fittings may not be accessible until the
steering wheel is turned or the motorhome is moved slightly.
Greasing
090368
Typical Zerk Fitting.
090418