330 | Section 8 Electrical System ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- ----------------- Monarch SE 2004
The bulbs inside the halogen lighting are replaceable.
To Replace a Bulb:
1. Remove outer trim ring by rotating outer trim ring counter-clockwise.
2. Remove safety lens by pressing lens towards a retaining tab. Pull lens
down and away.
3. Carefully grasp bulb and pull bulb from socket.
4. Use a clean cloth or piece of tissue to grasp new bulb. Do not touch
bulb directly as this can cause a "hot spot" and may result in
immediate bulb failure.
5. Align contacts of bulb with terminals in fixture base. Insert bulb until
contacts are firmly seated.
6. Replace safety lens.
7. Align tabs in trim ring with slots in fixture base. Rotate lens clockwise
until trim ring locks into place.
CAUTION: Do not touch halogen lighting while on. They can cause a
burn. Do not touch replacement bulbs. Oil in the hands can cause a
"hot-spot" to occur. If the bulb is touched, clean cooled bulb with
alcohol.
LIGHTS -
Interior Halogen
060200b
To Next Page
Loading...