Monarch SE 2004 - Front Axle - Workhorse; Oil Filled Bearings

338 | Section 9 Under Hood ---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- ----------------- Monarch SE 2004
All front axles use oil to lubricate the wheel bearings. Inspect the oil level
before every trip and every 5,000 miles. The oil is drained and refilled without
removing the wheel end assembly. Remove hubcap to access the bearing cover and
drain plug.
To Inspect the Oil Level:
• Remove the chrome hubcap.
• Locate the full and add mark on the outside of the clear plastic cover.
• If the lubricant level is low, add the recommended fluid until full.
The recommended oil change interval is based on the operating conditions,
speeds and loads. Limited service applications may allow the recommended
interval to be increased. Severe applications may require the recommended interval
to be reduced. For more information, contact a Westport service representative.
FRONT AXLE -
WORKHORSE
Oil Filled Bearings
090311b