Monarch SE 2004------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ S e ction 2 Driving & Safety | 47
• Ensure all conditions have been met to operate the leveling system.
• Press the ON/OFF label on the control panel. The ON/OFF label will
illuminate indicating the system is now operational.
• Should the ON/OFF label not illuminate, verify all conditions have
been met.
• Press the FRONT JACK label until the jack contacts with ground.
This will be felt in the motorhome.
• The FRONT JACK and REAR JACK labels will be used to achieve
a center in the level vial which is pointed front to rear of the
motorhome. The air bubble will indicate the high side of the
motorhome. Press the button that is opposite the air bubble in level
vial (i.e. if bubble is towards front of coach press the REAR JACK
label). Keep label pressed until the air bubble is centered in vial.
• The air bubble in the level indicator indicates the high side of the
motorhome. Push the button opposite of the bubble, either LEFT or
RIGHT REAR JACK, to level the motorhome.(i.e. If the bubble is
towards left of the coach push RIGHT REAR JACK). Keep the
label depressed until the bubble is centered in the vial.
NOTE: Right and left rear jacks are used to level the motorhome
side to side. Pushing the “LEFT REAR JACK” label on the
control panel will extend the left rear jack. Pushing the “RIGHT
REAR JACK” label on the control panel will extend the right rear
jack. There is no individual control for right or left front jacks.
Park the motorhome on reasonable solid surface. The jacks may sink into
ground on extremely soft surfaces. A load distribution pad or block may be placed
under each jack. The system is not designed to lift the wheels off the ground.
Doing so may create an unstable condition.
Leveling the
Motorhome
To Next Page
Loading...