42 | Section 2 Driving & Safety -------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- ----------------- Monarch SE 2004
The motorhome is prewired with a trailer wire harness.
The harness is located on or near the hitch receiver.
Convoluted tubing protects the tow harness wires. Current
draw should not exceed ten amps for each designated
circuit.
NOTE: When towing a trailer or vehicle
with a two-wire system, a turn signal/brake
light converter will be needed to adapt the
tow plug wiring to the item being towed.
The motorhome can be equipped with a rear vision and voice system. The
factory will provide the wiring behind the dash and at the rear cap for future
installation. The rear vision system consists of a camera with a microphone and a
monitor.
The rear view system is designed to provide the driver with a view of the rear
of the motorhome. The field of view is 140° in the diagonal plane, 121° in the
horizontal plane, and 90° in the vertical plane.
The driver can see what is behind the motorhome and listen to an assistant.
This is useful during backing procedures. The rear vision system will automatically
turn ON when the gear selector is placed in reverse. Turning the main power
switch ON will allow continuous operation of the rear vision system when the
ignition key is ON.
Power Switch:
The switch, when ON (in) position, engages the monitor for
viewing. The green LED indicator illuminates. When the switch is
OFF (out), the monitor is in a standby mode of operation. The
green LED remains illuminated when the ignition is on. The
monitor displays rear viewing when the transmission is shifted to
Reverse.
Camera Selector:
This switch should be left in the CA1 (out) position. CA2 (in)
position is not used in the motorhome.
REAR VIEW
SYSTEM
(Optional)
080370B
Tow Plug Connection
080420
To Next Page
Loading...