Monarch SE 2004-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Section 8 Electrical System | 291
If a circuit breaker trips in the main AC breaker panel, or on the generator
control panel, there may be a short circuit or too many loads.
NOTE: The generator will continue to run after a circuit
breaker trips.
If any circuit breaker trips, disconnect or turn off as
many loads as possible. To reset the circuit breaker, switch
the circuit breaker to OFF then switch back to ON to
reconnect the circuit. If the circuit breaker immediately
trips, the electrical distribution system has a short or the
circuit breaker is faulty. Call a qualified electrician. If the
circuit breaker does not trip, reconnect a combination of
loads that will not overload the generator or cause the
circuit breaker to trip again. Remember to compensate for
elevation and temperature changes when reconnecting loads.
NOTE: An appliance or load may have a short if it causes a
circuit breaker to trip after reconnecting. DO NOT continue to
reset breaker. Have the problem corrected before resuming
operation.
Resetting the
Circuit Breakers
To Next Page
Loading...