Monarch SE 2004 - Slide-Out Extending; Slide-Out Retracting

Monarch SE 2004--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Section 5 Equipment | 199
To Extend Slide-Out Rooms:
• Confirm that there is enough clearance
outside the motorhome for the slide-out
room and awnings to extend.
• The storage bay doors under the slide-outs
must be closed.
• If applicable, remove locking bar
mechanisms inside the motorhome.
• Move the driver's seat forward if moving the
roadside slide-out.
• Ensure the ignition key is in the OFF
position
• The park brake must be applied.
• The house batteries are fully charged.
• Ensure all people, pets and objects are clear
of the slide-out room path.
• The control switches for the slide-out rooms are located on
the systems monitor panel.
• Press and hold the slide-out room switch in the OUT
position. The slide-out room will slowly move to the OUT
position. Release the switch to stop room movement. To
continue the room movement, push and hold the switch in.
• Release the slide-out switch when the room is fully
extended.
• Extend any other slide-out rooms.
• Level the motorhome with the leveling system.
NOTE: If the slide-out room is extended in snow, sleet, ice, or
freezing rain extensive damage could occur to the slide-out room
and awning. In such conditions clear the awning and ensure free
movement prior to operating the slide-out room.
To Retract the Slide-Out Room:
• Inspect the exterior to ensure all bay doors are closed and there are no
sags in the awning material.
• Remove any debris from the top of the slide-out room.
• Retract the leveling system.
• Check for sufficient clearance inside the motorhome.
• Clean the floor to ensure there is no dirt or grit that could result in
floor damage during operation.
• Move the driver's seat forward before moving the roadside slide-out.
• The park brake must be applied.
• Ensure the ignition key is in the OFF position.
Slide-Out Extending
Slide-Out
Retracting
030802C
MVC-046G