Monarch SE 2004 - Page 156

156 | Section 4 Appliances ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ ----------------- Monarch SE 2004
Automatic Mode Operation:
When the refrigerator is in AUTO mode, it automatically uses the most
efficient energy source that is available for operation. During operation, if a more
efficient energy source becomes available, the refrigerator controls change from
the current energy source to the more efficient energy source as follows:
The first choice is AC operation if 120 Volts AC is available to the refrigerator.
The second choice is propane gas operation if 120 Volts AC is not available to the
refrigerator.
1. If AUTO and AC bars appear in the center display, it means:
- 120 Volt AC power is available to the refrigerator.
- The refrigerator is operating on AC electric power.
2. If AUTO and LP GAS bars appear in the center display, it means:
- 120 Volt AC power is not available to the refrigerator.
- The refrigerator is operating on propane gas.
Setting Controls for Automatic Mode Operation:
• Push the ON/OFF button to turn the refrigerator on.
• Push and hold the MODE button until the light bar shows beside
AUTO and then release.
If 120 Volts AC is available to refrigerator:
- The light bar beside AC also shows in the center display.
- After ten seconds, the light bar beside AC goes off and only the light
bar beside AUTO remains.
- The refrigerator is operating on AC electric.
If 120 Volts AC is not available to refrigerator:
- The light bar beside AC also shows in the center display.
- After a few seconds, the light bar beside AC goes off and the light bar
beside LP GAS shows.
- After 10 seconds, the light bar beside LP GAS goes off and only the
light bar beside AUTO remains.
- The refrigerator is operating on propane gas.
If an energy source is available to refrigerator, but is not operating
correctly:
• A fault code shows in the center display.
• Refrigerator controls try to change to a less efficient energy source.
If a less efficient energy source is not available:
• A fault code shows in the center display.