182 | Section 4 Appliances ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------ ----------------- Monarch SE 2004
To Conduct the Test Procedure:
1. Set the selector knob to Reset.
2. Set the Dry Timer knob to 30 minutes. Push the On/Off button to On.
Wait five seconds. The Auto Dry light should be on and the Status
light flashes fast then slow.
3. Set the selector knob to a wash cycle. Set Wash Temp knob to Warm.
Water should be flowing into washer and drum should rotate both
directions.
4. Set the selector knob to Reset. Wait five seconds.
5. Set the selector knob to Spin. Water should drain and drum rotation
should speed up.
6. Set the selector knob to Reset. Wait five seconds.
7. Set the selector knob to Dry. Dryer fan should begin and drum should
rotate both directions.
8. Set the selector knob to Reset. Wait five seconds.
9. Set the Dry Time knob to zero. The Auto Dry light should go off.
10. The door will unlock in two minutes or less. The Status light flashes fast then
slow. The door should now open.
11. Push the On/Off button to Out (Off) position. The Status light should be off.
WARNING: Do not wash or dry articles that have previously been
cleaned, washed, soaked or spotted with gasoline, dry cleaning sol-
vents or other flammable or explosive substances. They give off vapors
that could ignite or explode. Do not add gasoline, dry cleaning solvents or
other flammable or explosive substances to the wash water. Do not use
heat to dry articles containing foam rubber or similar textured,
rubber-like materials.
031017
To Next Page
Loading...