Motorola IRRInet-XL - Page 74

4-5
Table 4-1 The CMU P3 Jumper and Site Configuration settings per Radio and / or
Wire Line:
P3 Jumper
(Channel Monitor)
set to …
Site Configuration
Port 2 | Channel Monitor
set to …
Radio with its
CM set to High
Short pins 1 & 2 High
Radio with its
CM set to Low
Short pins 2 & 3 High
Wire Line Only Short pins 2 & 3 High
Radio with its
CM set to High
+
Port 2 Wire Line
Short pins 1 & 2 High
Radio with its
CM set to Low
+
Port 2 Wire Line
Short pins 2 & 3 High
CM = Channel Monitor
N
N
o
o
t
t
e
e
:
:
Factory Default settings
CMU jumper P3 is: Short pins 1 & 2 (CM = High)
CMU jumper P2 is: Short pins 1 & 2 (Master)
Site Configuration sets Port 2 | Channel Monitor to High
StockCheck.com