4-3
Using Single Mobile Radio
To connect one Mobile Radio to both Port 2 (INTRAC) and Port 3 (MDLC) perform the
following wire connections (See Figure 4-3):
1. Connect the CMU power connector to the Power Supply Module “AUX”
connector using power cable (p/n: FKN4869). When powered on the CMU LED
should light.
2. Connect the CPU Port 2 to the CMU Port 2.
3. Connect the CPU Port 3 to the CMU Port 3.
4. Connect the CMU "Radio" to the Mobile Radio communications connector.
5. For CMU P3 Jumper and Site Configuration settings, refer to Table 4-1.
CPU Port2 to
CMU Port2
CMU Radio to
Mobile Radio
CPU Port3 to
CMU Port3
Figure 4-3 CMU Unit and Single Mobile Radio - User Connections
To Next Page
Loading...
