Maintenance & Troubleshooting 6 - 7
During data
communication, no
data transmits, or
transmitted data was
incomplete.
EDA removed from
cradle during
communications.
Replace EDA in cradle and retransmit.
Incorrect cable
configuration.
See the system administrator.
Communication
software is not
installed or
configured
properly.
Perform setup as described in the MC70 Integrator Guide.
Table 6-3
Troubleshooting the Single Slot USB/Serial Cradle (Continued)
Symptom Possible Cause Action
To Next Page
Loading...
Need help?
General
