Getting Started 1 - 9
SIM Card
GPRS phone service requires a Subscriber Identification Module (SIM) card, or smart card. Obtain this card
from the phone service provider. The card fits into the EDA and can contain the following information:
•
Mobile phone service provider account details.
•
Information regarding service access and preferences.
•
Contact information, which can be moved to Contacts on the EDA.
•
Any additional services to which you have subscribed.
To install the SIM card:
1. Press the red Power button to suspend the EDA.
2. Remove the battery.
3. Lift the SIM cover using the stylus tip.
Figure 1-8
Lifting the SIM Cover
4. Insert the SIM card, as shown in Figure 1-9, with the cut edge of the card facing out and the contacts facing
down.
Figure 1-9
Inserting the SIM Card
5. Lower the SIM cover and snap it in place.
6. Replace the battery and battery cover.
NOTE MC7004 and MC7094 only.
NOTE For more information about SIM cards, refer to the mobile phone service provider's documentation.
SIM Cover
To Next Page
Loading...
Need help?
General
