1 - 12 MC70 User Guide
Changing the Power Settings
To set the EDA to turn off after a short period of non-use:
1. Tap Start > Settings > System > tab > Power icon > Advanced tab.
2. Select the On battery power: Turn off device if not used for check box and select a value from the
drop-down list.
3. Select ok.
Changing the Backlight Settings
To change the backlight settings in order to conserve more battery power:
1. Tap Start > Settings > System tab > Backlight icon > Battery Power tab.
2. Select the Disable backlight if device is not used for check box and select a value from the drop-down
list.
3. Select the Brightness tab.
4. Tap the Disable backlight check box to turn off the display backlight, or use the slider to set a low value
for the backlight.
5. Select ok.
Changing the Keypad Backlight Settings
To change the keypad backlight settings in order to conserve more battery power:
1. Tap Start > Settings > System tab > Keylight icon > Battery Power tab.
2. Select the On battery power: Disable keylight if device if not used for check box and select a value from the
drop-down list.
3. Select the Advanced tab.
4. Tap the Disable keylight check box to turn off the keypad backlight.
5. Select ok.
Turning Off the Radios
On Devices with AKU 1.0
Turning Off the WLAN Radio
To turn off the WLAN radio, tap the Signal Strength icon and select Disable Radio. A red X appears across the
icon indicating the radio is disabled (off).
To turn the WLAN radio back on, tap the
Signal Strength icon and select Enable Radio. The red X disappears
from the icon indicating the radio is enabled (on).
NOTE To determine the operating system AKU version, see Configurations on page xii.
To Next Page
Loading...
Need help?
General
