Chapter 4
Using the MC7004/94/95 Phone
Chapter 4
Using the MC7004/94/95 Phone
Introduction
Use the MC7004, MC7094 and MC7095 phone to make phone calls, set up speed dials, keep track of calls,
and send text messages. Your wireless service provider may also provide other services such as voice mail,
call forwarding, and caller ID.
Also use the integrated phone to connect to an ISP or work network in order to browse the Web and read
e-mail. Connect to the Internet or work network over General Packet Radio Services (GPRS) (MC7004 and
MC7094) or Evolution Data-Optimized (EvDO) (MC7095) using Cellular Line, or using the modem specified by
the mobile operator. For more information, or to customize the EDA phone by changing phone settings, see the
MC70 Integrator Guide.
Accessing the Phone Keypad
Access the keypad regardless of the program in use. Applications on the EDA can be in use during a call.
Figure 4-1
Phone Keypads
To access the phone keypad tap
Start > Phone or press the green phone key on the EDA’s keypad.
Antenna/Signal
NOTE Keypads vary depending on services and the state of the phone. For example, place calls on hold and use
Swap to switch active calls on hold. (See Three-way or Conference Calling on page 4-14.)
To Next Page
Loading...
Need help?
General
