Motorola MC70 User Manual

6 - 8 MC70 User Guide
Four Slot Ethernet Cradle
Table 6-4 Troubleshooting the Four Slot Ethernet Cradle
Symptom Cause Solution
Attempt by the EDA
to ActiveSync failed.
EDA removed from
the cradle while
the LED was
blinking green.
Wait one minute and reinsert the EDA in the cradle. This allows
the cradle to attempt another synchronization.
Using an outdated
version of
ActiveSync.
Visit http://www.microsoft.com for the latest ActiveSync
software.
ActiveSync on the
host computer has
not yet closed the
previous
ActiveSync
session.
Wait one minute and reinsert the EDA in the cradle. This allows
the cradle to attempt another synchronization.
Incorrect cable
configuration.
Ensure the correct cable (Ethernet) is used with the cradle.
Communication
software
improperly
configured.
Perform setup as described in the MC70 Integrator Guide.
EDA ActiveSync
disabled or not
configured to
accept network
connection.
On the EDA, tap
Start > ActiveSync > Tools > Options > Options
button. Then, uncheck the
Enable PC sync using this
connection: check box.
Host ActiveSync
disabled or not
configured to
accept network
connection.
On the host computer, check
File > Connection Settings > Allow
network (Ethernet) Server Connection with this desktop
computer.
During
communication, no
data transmits, or
transmitted data was
incomplete.
EDA removed from
cradle during
communications.
Replace EDA in cradle and retransmit.
EDA has no active
connection.
An icon is visible in the status bar if a connection is currently
active.

Motorola MC70 Specifications

General

Brand	Motorola
Model	MC70
Category	PDA
Language	English