3 - 4 MC70 User Guide
Suspend
Suspending the EDA turns off Bluetooth.
Resume
When the EDA resumes, Bluetooth turns on if it was on prior to suspend.
Bluetooth Profiles
The mobile computer is loaded with a number of Bluetooth services profiles. These profiles can be loaded or
removed from memory. If a profile is not used, it can be removed to save memory. To load or remove profiles:
1. Tap > Programs > BTProfileSelctor. The ProfileSelector window appears.
Figure 3-3
Bluetooth Profile Selector Window
2. Tap a check box next to the profile to load (activate).
The Serial Port profile is always active and cannot be removed.
3. Tap Select All to select all profiles or tap Deselect All to deselect all profiles.
4. Tap Apply to activate the profiles and then Close to exit the application.
See Services Tab on page 3-24 for more information on selecting services.
Modes
The BTExplorer application has two mode for managing Bluetooth connections: Wizard Mode and Explorer
Mode. The Wizard Mode is for novice Bluetooth users and the Explorer Mode is for experienced Bluetooth
users. To switch between modes, select
View > Wizard Mode or View > Explorer Mode.
NOTE Suspending the EDA powers off the Bluetooth radio and drops the piconet (Bluetooth connection). When
the EDA resumes, it take approximately 10 seconds for the Bluetooth radio driver to re-initialize the radio.
To Next Page
Loading...
Need help?
General
