3 - 16 MC70 User Guide
Before setting up dial-up networking, obtain dial-up information and other necessary settings for the office
network or ISP. To create a new Bluetooth connection:
1. Ensure the EDA is discoverable and connectable. See Bluetooth Settings on page 3-24.
2. Discover and bond (pair) with the remote device. See Bonding with Discovered Device(s) on page 3-9.
3. In BTExplorer, select the Remote Devices folder.
4. Select the Trusted Devices folder.
5. Tap the remote device folder.
6. Tap and hold on Dial-up Networking and select Connect from the pop-up menu. The Select Dial-up
Networking Entry
window appears.
Figure 3-22
Select Dial-up Networking Entry Window
7. Select a dial-up entry.
8. Tap OK. The EDA begins to communicate with the phone. If required, the phone requests permission to
communicate with the EDA.
9. Confirm the connection on the phone. The Network Log On window appears.
Figure 3-23
Network Log On Window
NOTE If a dial-up entry is not listed, see Adding a Dial-up Entry on page 3-17.
To Next Page
Loading...
Need help?
General
