Motorola MTH800 User Manual

109
The Menu
• No access to network operation — you can only send or
receive Emergency Calls and adjust the volume level. Unit
lock takes effect at the next power on.
To protect access to network operation:
1. From the main menu, select Security > PIN Protect. On is
highlighted.
2. Press Select.
3. At the Code? prompt enter the 4-digit code (factory setting
0 0 0 0). To avoid disclosure of the code, asterisks are
displayed instead of the code digits. The display will show
the following message:
Unit Locked — you entered the correct code. The display
returns to the Security sub-menu and shows the active
setting: On.
To unlock the MTH800 before powering off:
1. From the main menu, select > Security > PIN Protect. Off
is highlighted.
2. Press Select.
3. At the Code? prompt enter the 4-digit code.The display will
show the following message:
Unit Unlocked — You entered the correct code. The display
returns to the Security sub-menu and shows the active
setting: Off
.
To unlock the MTH800 after powering on, enter the code at
the prompt. The MTH800 enters the Home display.
If you fail to enter the correct code, the following message will
be displayed:
Incorrect Code Entered — You are prompted to try again.
After failing, your MTH800 will be blocked. Please check with
your Service Provider how many failed attempts are allowed.
How to unblock the MTH800
The display shows Unit Blocked. You can send an
Emergency Call.

Motorola MTH800 Specifications

General

Frequency Range	380-430 MHz
Operating Temperature	-30°C to +60°C
Ingress Protection	IP54
RF Power Output	1W
Battery Type	Li-Ion
Channels	1000