Motorola MTH800 User Manual

30
The terminal will alert you of the modification and will display
the following messages, depending on the type of call:
•
Call Modified (to full-duplex)
•
Call Modified Use PTT (modified to half-duplex)
Continue the modified call depending on the type of call.
Receiving Calls
The MTH800 will automatically receive the incoming call.
Additionally, if Inactivity Revert Mode is enabled, the MTH800
returns automatically to the Home display, after that call
ends.
Your MTH800 will alert you of an incoming call depending on
the setting you selected in the Vibrate menu option (see
page 114) and the Tones menu option (see page 119).
During message editing, you will be alerted of an incoming
Group/Emergency/Broadcast Group Call if configured by
your Service Provider.
Pre-emptive Calling
Pre-emptive calling is particularly useful when you need to
speak urgently with a user whose terminal is busy in a non-
emergency voice call.
A pre-emptive priority call (PPC) is either an Emergency
Group Call or a Private PPC (half-duplex or full-duplex call).
The feature allows to disconnect the on-going lower priority
call and to connect to the incoming higher priority call.
• Half-duplex Private Call modified from direct setup to hook
setup:
a ringing tone will alert of the change.
• Half-duplex Private Call modified from hook setup to direct
setup:
there will be no indication of the change.
Inactivity Revert Mode will occur if configured by your Service
Provider.

Motorola MTH800 Specifications

General

Frequency Range	380-430 MHz
Operating Temperature	-30°C to +60°C
Ingress Protection	IP54
RF Power Output	1W
Battery Type	Li-Ion
Channels	1000