63
Private Call
Receiving a Private Call in TMO
1. The MTH800 switches to the incoming Private Call. The
display shows the caller’s identity.
2. To answer an incoming half-duplex call, press PTT. To
answer an incoming full-duplex call (indicated by Spkr/
Erpc soft keys), press .
3. To end the call, press .
Private Call in DMO
If configured by your Service Provider it is possible to make
and receive a Private Call in DMO. You can make or receive
a DMO Private Call only when your MTH800 is in DMO.
The calling and called party shall be on the same talkgroup.
Making a Private Call in DMO
1. From the Home display enter a number.
Dialing via
• Contact List or
• Recent Calls Lists
works like described in “Other Ways of
Dialing” on page 61.
2. Press and hold PTT. Wait for the talk permit tone (if
configured) before talking, and release the PTT when
listening.
3. The call ends after a pre-programmed time, or if you
press .
Your terminal can alert you of an incoming call. Select the alert
settings in the Vibrate menu and Tones menu items
Private Calls via DMO Repeater and/or DMO Gateway are not
supported.
There is no presence check for Private Calls in DMO. This
means you don’t know whether the called party is available
when you starts the call.
Private #:
Ctype Delete
To Next Page
Loading...
Need help?
General
