29
Getting Started
Non-Emergency calls:
• Pressing PTT
If the call type is “Group” or Private”, then pressing PTT shall
initiate Group or private simplex call accordingly. Otherwise
special indication shall be given to the user.
• Pressing
Send key
If the call type is “PABX” or “Phone” or “Private”, then
pressing Send shall initiate PABX or Phone or full duplex
private call accordingly. Otherwise special indication shall be
given to the user.
Incoming Calls During Dialing
MS shall remain affiliated to the last Talk Group and receive
any group calls. Incoming call will be indicated to the user
and the dialing process will be interrupted. Non-emergency
call will not suspend dialing but the user will be able to hear
the signal. When the radio receives private or phone call, MS
will indicate and give the option to the user to reject or accept
the call. If the user accept the call, dialing process will end.
When reject is pressed, user will be back in dialing process.
Entering Emergency Mode During Dialing
Dialing process stops when, meanwhile, the user tries to go
to emergency mode
Incoming SDS message during dialing
SDS message is indicated and interrupts the dialing process.
Changing Call Type
By dialing from the idle screen the user will be given the
possibility to change the Type of the Call.
Modifying the Type of Call
The infrastructure can modify the type of call you started.
For example, you might start a half-duplex Private Call, and
the infrastructure could modify the call to a Group Call.