57
DMO Group Call
> If it is successful your MTH800 will display the
message Repeater Call and a call via repeater will
proceed. The Gateway icon will disappear.
> If it is not successful your MTH800 will display the
message MS-MS Call and a terminal to terminal call
will proceed. The Gateway and Repeater icons will
disappear.
• If you press PTT while both gateway and repeater are
available, a gateway call will be attempted.
> If it is successful your MTH800 will start a DMO call
with gateway. The Gateway icon will be solid. The
Repeater icon will disappear.
> If synchronising with a gateway is not successful a
repeater call will be attempted.
> If it is successful your MTH800 will display the
message Repeater Call and a repeater call will
proceed. The Gateway icon will disappear and the
Repeater icons will be solid.
> If it is not successful your MTH800 will display the
message MS-MS Call and a terminal to terminal call
will proceed. The Gateway and Repeater icons will
disappear.
Receiving a DMO Group Call
You can receive a DMO Group Call only when your MTH800
is in DMO.
Your MTH800 will display the caller’s private number or alias,
and the talkgroup name.
If Gateway and Repeater mode is selected, and if one of the
devices is not available, the call setup is proceeding as if this
device was not selected.
Example
: In case of the Gateway is available and the Repeater
is not available, after an unsuccessful Gateway call attempt the
call falls back to MS - MS mode immediately with the MS-MS
call message.
To Next Page
Loading...
