Motorola MTH800 User Manual

131
The Menu
> To select a folder, scroll through the folder list. The list
does not show folders whose groups are fully used in
the selected scan list. Press Ok to select a folder.
> To select a group, scroll through the group list within
the selected folder. The list shows groups that are not
in the selected scan list. Press Ok.
> To set a priority to a group, scroll through the priority
list: high, medium, or low.
A call from a high priority group will interrupt an on-
going call with a medium and low priority.
A call from a medium priority group will interrupt an
on-going call with a low priority.
A call from a low priority group will not interrupt any
on-going call.
• Edit the scan list groups.
> Scroll to the group you wish to remove from the
selected scan list, and press Delete. You will be
prompted to remove the selected group. After a few
seconds, the display shows the updated scan list.
> To change the group priority, press Priority
. Scroll to
the selected priority and press Select.
My Groups (TMO/DMO)
This sub-menu allows you to select/edit your
favorite group list.
Adding a Group
1. From the main menu, select More... >
Group Setup > My Groups > <FolderName> > [New
Group].
2. Select a group by folder search (“TMO/DMO by Folder”).
Select the folder and select the group. The group is added
to the “My Groups” folder. OR, select a group by alphabetic
search (“TMO/DMO by abc”). You can enter up to 12 letters
of the group’s name.
My Groups
[New Folder]
Select Back
My Groups

Motorola MTH800 Specifications

General

Frequency Range	380-430 MHz
Operating Temperature	-30°C to +60°C
Ingress Protection	IP54
RF Power Output	1W
Battery Type	Li-Ion
Channels	1000