Motorola MTH800 User Manual

52
Gateway/Repeater Selection
Use the DMO Config sub-menu for setting
the Gateway and Repeater options.
1. Press Optns to enter the options menu in
DMO.
2. Scroll to Config, and press Select.
Selecting DMO Group Call MS to MS
To change from gateway or repeater mode to
MS - MS mode (DMO terminal to terminal call):
1. Press Optns, scroll to Config and press
Select.
2. Scroll to MS - MS and press Select. The
following message to be displayed for a few
seconds: MS - MS Will Be Used.
Selecting DMO Group Call via Gateway
While in DMO, proceed as follows to choose a gateway to set
up a call via Gateway for the selected talkgroup:
1. Press Optns, scroll to Config and press Select.
2. Scroll to Gateway and press Select.
3. The display shows the last gateway selection method. Use
the navigation key to scroll to your selection and press Ok:
DMO Folder 1
Police
Hello
Optns Contcs
DMO Folder 1
Police
Hello
DMO Options sub-menu
Folder
TG by Folder
TG by abc
Trunked Mode
Config
1 MS - MS
2 Gateway
3 Repeater
4 GW + Rep
1 Automatic
2 Specific
1 Automatic
2 Specific
DMO Options
Folder
TG by Folder
TG by abc
Trunked Mode
Select Back
Config
Config
MS - MS
Gateway
Repeater
GW + Rep
Select Back

Motorola MTH800 Specifications

General

Frequency Range	380-430 MHz
Operating Temperature	-30°C to +60°C
Ingress Protection	IP54
RF Power Output	1W
Battery Type	Li-Ion
Channels	1000