128
Setting Group Scanning
This sub-menu allows you to activate/deactivate the
scanning of a list of pre-defined groups programmed in the
MTH800. The MTH800 will join any group call as long as this
group is defined in the scan list and scan is turned on.
From the main menu, select More > Group Setup > Scan >
Scanning.
After completing the settings, the display returns to the Scan
sub-menu.
Set Scanning to On
Scanning is Off. Select On. A message may
indicate that all scan lists are empty. Select
Scan Lists to fill the scan list(s).
The display shows the following state:
Then, the display shows (for example) the
Scanning Scan List 1 message. The
terminal will then try to attach to this list.
Set Scanning to Off
Scanning is on. Select Off. The display
shows the following state:
Then, the display shows the Scanning is
Off message.
Selecting a List with Scanning On
1. Select Select List.
2. To select a list other than the highlighted
one, scroll and press Select. The display
shows (for example) the Scanning Scan
List 1 message. The terminal will then try
to attach to this list.
Selecting a List with Scanning Off
1. Select Select List.
Scanning
On
Select List
Select Back
Scanning
Off
Select List
Select Back
Scan Lists
Network List
Scan List 1
Select Back
Network List
Scan List 1
To Next Page
Loading...
