Chapter 4 Symbologies
Introduction
This chapter describes symbology features and provides the programming bar codes for selecting these features
for the scanner. Before programming, follow the instructions in Chapter 1, Getting Started.
The scanner ships with the settings in Table 4-1 on page 4-2 (also see Appendix A, Standard Default Parameters
for all scanner defaults). If the default values suit requirements, programming is not necessary. Set a feature value
by scanning a single bar code or a short bar code sequences. To return all features to default values, scan Reset
on page 3-4.
Scanning Sequence Examples
In most cases, scan only one bar code to set a parameter value. For example, to transmit bar code data without the
UPC-A check digit, scan the
Do Not Transmit UPC-A Check Digit bar code under Transmit UPC-A Check Digit on
page 4-13. The scanner issues a fast warble beep and the LED turns green, indicating a successful parameter
entry.
Other parameters, such as Set Length(s) for D 2 of 5 require scanning several bar codes in sequence. See the
parameter description for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, re-scan the correct parameter.
To Next Page
Loading...
Need help?
General
