To Next Page

To Previous Page

4 - 30 Symbol CS3000 Series Scanner Product Reference Guide

Code 11

Enable/Disable Code 11

Parameter # 0x0A

To enable or disable Code 11, scan the appropriate bar code below.

Enable Code 11

(0x01)

*Disable Code 11

(0x00)

Set Lengths for Code 11

Parameter # L1 = 0x1C, L2 = 0x1D

The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)

the code contains. Set lengths for Code 11 to any length, one or two discrete lengths, or lengths within a specific

range.

•

One Discrete Length - Select this option to decode only Code 11 symbols containing a selected length.

Select the length using the bar codes from Numeric Bar Codes on page 4-48. For example, to decode only

Code 11 symbols with 14 characters, scan Code 11 - One Discrete Length, then scan 1, then 4. To correct

an error or to change the selection, scan Cancel on page 4-50.

•

Two Discrete Lengths - Select this option to decode only Code 11 symbols containing either of two

selected lengths. Select lengths using the bar codes from Numeric Bar Codes on page 4-48. For example,

to decode only Code 11 symbols containing either 2 or 14 characters, select Code 11 - Two Discrete

Lengths, then scan 0, 2, 1, and 4. To correct an error or to change the selection, scan Cancel on page

4-50.

•

Length Within Range - Select this option to decode a Code 11 symbol with a specific length range.

Select lengths using the bar codes from Numeric Bar Codes on page 4-48. For example, to decode Code

11 symbols containing between 4 and 12 characters, first scan Code 11 - Length Within Range. Then

scan 0, 4, 1, and 2 (include a leading zero for single digit numbers). To correct an error or change the

selection, scan Cancel on page 4-50.

•

Any Length - Scan this option to decode Code 11 symbols containing any number of characters within the

scanner’s capability.

Motorola Symbol CS3000 Series User Manual

Other manuals for Motorola Symbol CS3000 Series